Set-Up; Confirmation Of The Software Version; Setting About The System - Sony HDS-7150 Installation Manual

9-3. Set-up

The processes to construct the system are described below.
Basically set up in the following sequence.
However, it is not necessary to set the item again whose setting is not changed.

1. Confirmation of the Software Version

2. Setting about the System

3. Setting of the Crosspoint table
4. Assigning of the Crosspoint
5. Assigning of DME (Digital Multi Effects)
6. Assigning of the Key Sources to Key Fill (When Key Source Auto Select Mode is selected)
7. Setting of the Switcher Input Signal
8. Setting of the Switcher Output Signal 1
9. Setting of the Switcher Output Signal 2
10. Setting about the Change of Synchronized Signal Assignment
11. Setting of the Internal Generation Matte Signal
12. Setting of the GPI Input
13. Setting of the GPI Output
14. Setting of the Operation Mode
n
If interrupting or terminating the set-up and saving the data into the nonvolatile memory, perform "9-4.
Saving Set-up Data to Nonvolatile Memory".
After setting each item (Returning to the menu screen)
After setting each item, press the EXIT button.
The display changes to the previous menu screen.
ex.) [SETUP]
(Set-up menu screen)
EXIT button
n
In the menu screen that fixes the set value using the [F10] (EXEC) key, be sure to press the [F10] key
before pressing the EXIT button. If the [F10] key is not pressed, the changed set value is not stored and
returns to the original set value before changed.
HDS-7150/7100
[1] (SYSTEM) [F3] (SYSTEM SETUP)
(System setting screen) (System set-up screen)
EXIT button
[F3] (LINE)
(Line setting screen)
EXIT button
HDS-7150
9-3. Set-up
9-7