Bosch Conettix D6600 Manual page 179

Conettix D6600/D6100IPv6/D6100i | Computer Interface Manual | Appendix I: SafeCom Messages
(D6600 Only)
.
Table 125:
Code Meaning
D7 Fail to open.
D6 Fail to close.
D5 Area watch by user ZZZ.
A6 Perimeter delayed by user ZZZ.
A5 Passcode for user ZZZ deleted.
A4 Point bus restore.
A2 Transmitter point ZZZ battery low.
A1 Transmitter point ZZZ battery restore.
A0 Transmitter point ZZZ tamper
9F RF receiver trouble by SDI device ZZZ.
9A Extra RF point ZZZ.
99 RF receiver restore by SDI device ZZZ.
98 RF interference by SDI device ZZZ.
95 Transmitter point ZZZ tamper alarm.
94 Transmitter point ZZZ tamper trouble.
92 Equipment restoral by SDI device ZZZ.
91 Card assigned by user ZZZ.
90 Card deleted by user ZZZ.
8F Door cycled point ZZZ.
8E Door unlocked point ZZZ.
8D Door locked point ZZZ.
8C No entry point ZZZ.
8B Door left open point ZZZ.
8A Door request point ZZZ.
89 Network failure path ZZZ.
88 Network restoral path ZZZ.
87 Network condition path ZZZ.
86 Equipment fail by SDI device ZZZ.
85 Status supervision point ZZZ.
84 Fire Supervision Restoral point ZZZ.
83 Fire supervision point ZZZ.
82 Fire Supervision Trouble point ZZZ.
Fire Supervision Trouble Restoral point
81
ZZZ.
7F Status fire supervision point ZZZ.
7E Extra account path ZZZ.
7D Low signal strength path ZZZ.
7C RF receiver tamper by SDI device ZZZ.
Bosch Security Systems, Inc. | 2012.09 | 4998122703-05
Supported Event Codes (continued)
restore.
Code Meaning
AD Reboot
AC Parameter checksum failure.
AB Force perimeter instant by user ZZZ.
77 Status RF trans low battery point ZZZ.
76 Status RF trans tamper alarm point ZZZ.
75 Status RF trans tamper trouble point ZZZ.
74 Sensor Trouble point ZZZ.
73 Sensor Trouble Restoral point ZZZ.
72 Status fire missing point ZZZ.
71 Status missing alarm point ZZZ.
70 Status missing trouble point ZZZ.
6F Status door forced point ZZZ.
6E Door locked point ZZZ.
6D Missing fire supervision point ZZZ.
6C Missing supervision point ZZZ.
6B Status missing fire supervision point ZZZ.
6A Status missing supervision point ZZZ.
69 Status door left open point ZZZ.
68 Failed to execute point ZZZ.
5F Analog service point ZZZ.
5E Analog restoral point ZZZ.
5D Status analog service point ZZZ.
5C Test Failed path ZZZ.
5B External device ZZZ.
5A Custom Function ZZZ Executed.
59 Low Temperature point ZZZ.
58 Low Temperature Restoral point ZZZ.
56 Unverified Event point ZZZ.
55 Printer Status by SDI device ZZZ.
54 Abort by user ZZZ.
53 Service Request.
52 Output ZZZ State.
51 Output ZZZ State Restoral.
50 Bypass Restoral point ZZZ.
4F Alarm Silenced point ZZZ.
4E Alarm-Panel Substitution path ZZZ.
179