Bosch Conettix D6600 Manual page 138

Conettix D6600/D6100IPv6/D6100i | Computer Interface Manual | Appendix C: Modem4/Modem
IIIa
Table 100: User ID to Comex Translation
ID
0
1-5
0-13
14-21
22-29
30-37
38-45
46-53
54-61
62-69
70-249
2. When the D7112 is transmitting a test report in Modem II format, the area number is sent to the
automation system if the output format is in SIA communications mode.
3. When transmitted by a D7112, the identification number, if any, also prints. Refer to Forced Point in
the D9112B Program Entry Guide (P/N: 74-06145-000-D).
4. For these events, the area denotes the location of the keypad used to initiate the event (see Sensor
Reset).
5. BFSK Format: For the D9112, unless otherwise specified, the zone digit "z" uses the "BFSK Zone
Code" as a base for a given point. This code is programmed in the control panel by point. The zone
digit "i" indicates the most significant digit of the user ID.
138 Bosch Security Systems, Inc. | 2012.09 | 4998122703-05
COMEX
0
001-005
601-608
701-708
801-808
B01-B08
C01-C08
D01-D08
E01-E08
F01-F08
000