Advertisement
4-1. Setup Menu (BVP-500 series)
DISPLAY switch
ON
: Displays characters and messages indicating the video camera settings and operation status.
OFF
: No character or marker display appears on the viewfinder screen.
MENU : The setup menu appears on the viewfinder screen.
MENU SELECT knob
Selects the menu item or setting value displayed on the viewfinder screen.
MENU SELECT switch
ENTER : Enters the page/item select mode, or enters the setting values.
CANCEL : Cancels the contents of a menu setting, or returns to the page select mode or TOP menu.
n
The TOP menu screen indicates the entire configuration of menu items.
To display the TOP menu, set the DISPLAY switch to MENU (from OFF) while pushing up the MENU
SELECT switch to ENTER.
. . . . .
Basic Operation
1. Displaying the menu
To display the Operation menu, set the DISPLAY switch to MENU.
To display the other menus than the Operation menu, first of all, the TOP menu shall be displayed.
To display the TOP menu, set the DISPLAY switch to MENU while pushing up the MENU SELECT
switch to ENTER. Then turn the MENU SELECT knob to move the cursor to a menu item which
you want and push up the MENU SELECT switch to ENTER.
2. To shift the page, turn the MENU SELECT knob with a page scroll bar displayed at the top-right of
the screen until the desired page is displayed and push up the MENU SELECT switch to ENTER.
The menu enters the item select mode and the page scroll bar disappears.
3. To shift the item, turn the MENU SELECT knob until the → cursor points the item to be set and
push up the MENU SELECT switch to ENTER.
4. To change the value, turn the MENU SELECT knob. You can change the values quickly by
turning the MENU SELECT knob fast. You can make very fine adjustments by turning the switch
slowly. By pushing up the MENU SELECT switch to ENTER, the setting is entered.
5
The menu page is returned to the item select mode or page select mode every time the MENU
SELECT switch is pushed down to CANCEL.
6. To exit from the setup menu, set the DISPLAY switch to OFF.
. . . . .
ROM version
Contents in the menu and factory settings may differ from the descriptions in this manual depending on
the version of ROM (IC36) on the AT-126 board.
In this section, an item under "Ver." in the table shows a ROM version. If any version is given, it shows that
the function for the item is added or changed, and the ROM with that version or higher version supports the
function. If no version is given, it shows that every ROM version supports the function.
To confirm the ROM version easily proceed as follows:
1. Set the DISP switch to OFF.
2. Power the unit on while pushing up the MENU SELECT switch to ENTER. The indication of
ROM version is displayed for about three seconds.
4-2 (E)
BKP-5090
Advertisement
