Advertisement
3-1. Setup Menu
The Setup menu is used to select settings of camera operation, select items to be displayed on the view-
finder screen, and select the way the items are displayed.
It is also used for adjustment. The menu appears on the viewfinder screen.
By changing a setting through this menu, the same signal as output to the viewfinder is enabled to be
output at the TEST OUT connector.
. . . . .
Configuration of the Setup Menu
The setup menu consists of the following menus
. Operation menu
. Paint menu
. Maintenance menu
. Reference File menu
. Trimming File menu
. System config menu
Operation and Paint menus are normally accessible. To display the other menus, set switchs S1-1 to S1-4
on the AT-126 board as follows.
( ) in parentheses : Factory setting
S1-1
S1-2
ON (ON)
OFF (OFF)
. . . . .
Equipment required
CCD Unit
OHB-450/550 series
Camera Adaptor CA-530/550/570 series
Supply power from a camera control unit CCU-700A/700AP, AC adaptor AC-550/550CE or VTR.
. . . . .
Switches and Button
MENU SEL switch
MIC
LEVEL
<FRONT VIEW>
BKP-5090
Section 3
Setup Menu (BVP-550 series)
S1-3
S1-4
ON (OFF)
OFF (OFF)
DISP switch
DISP
ON
OFF
MENU
CANCEL button
CANCEL
3-1 (E)
Advertisement
