Advertisement
1-2. Installation Procedure
1-3. Installing the Backup battery
1-2. Installation Procedure
This section explains briefly on installation procedures. For details, refer to the corresponding section.
1. Installing the backup battery (Refer to Section 1-3.)
2. Attaching the PR-242/AT-126 board to the camera (Refer to Section 1-4.)
3. Modifying the VA-163 board of the camera (Refer to Section 1-5.)
4. Modifying the DA-88 board of the camera (Refer to Section 1-6.)
5. Checking the ROM version (Refer to Section 1-7.)
6. Electrical alignment (Refer to Sections 2-1 to 2-3.)
7. Installing the BKP-5091 (Refer to Section 2-4.)
8. CCD dynamic range adjustment (Refer to Section 2-5.)
9. File store (Refer to Section 2-6.)
1-3. Installing the Backup battery
Install the supplied battery into the battery holder (BT1) on the AT-126 board.
c
Ensure that the battery is installed with "+" and "_" poles connected to the correct terminals.
An improper connection may cause an explosion or leakage of fluid.
1-2 (E)
BKP-5090
Advertisement
