Advertisement
3-1. Setup Menu (BVP-550 series)
3-1-6. System Config Menu
Page
Ver.
Item
Others1
Filter,
WHT MEM
NTSC ENC
Rotation
Own Call
Center MKR H
Center MKR V
Lens VTR S/S
VF ? Display
PinP RET RVS
3-18 (E)
Settings
Contents
[On], Off
On
: A total of 8 settings of the white balance value can be saved
Off
: One white balance value can be saved for the WHITE BAL
[Wide], Narrow
Sets the band width of the Q signal for the NTSC color encoder.
[STD], RVS
Selects the mode of MENU SEL switch (as turned counterclockwise
when viewed from the front.)
STD : Cursor moves downwards and a numeric value increases.
RVS : Cursor moves upwards and a numeric value decreases.
R, F&R , Off
Selects whether one or two TALLY lamps are lit corresponding to the
CALL button of camera adaptor pressed, or not. Or selects which
TALLY lamp is lit when the CALL button is pressed.
(This setting is valid in connection with CCU. When the camera is used
alone and MSU/RCP is not connected to the camera, it is always set to
OFF.)
R
: Rear TALLY lamp is lit.
F&R : Rear and front TALLY lamps are lit.
Off
: No TALLY lamp is lit corresponding to the CALL button.
_20 to 20 ([XX])
Shifts horizontally the location of the center marker on the screen.
20 (right) ↔ _20 (left)
_20 to 20 ([XX])
Shifts vertically the location of the center marker on the screen.
20 (up) ↔ _20 (down)
Talk, [RET2]
Selects the mode of VTR S/S SW of the lens and camera.
Talk : VTR S/S SW of lens functions as INCOM TALK SW
RET2 : VTR S/S SW of lens functions as RET2 SW and that of the
[On], Off
Turns on and off the indication of ? mark at the top-right of the VF
with the DISP switch set to ON when the self-diagnosis result is NG (no
good) and so on.
[RVS1], RVS 2, Off
Selects the indication mode of VF display in PinP mode. (Does not
function in the unit.)
in conbination with the CC filter and WHITE BAL switch settings.
switch setting A or B, for a total of 2 settings.
(momentary) and that of the camra as RET2 SW.
camera as INCOM TALK SW.
BKP-5090
Advertisement
