Siemens SINUMERIK Series Function Manual page 69

03/2012
Note
Contour test:
Running-in the axis test - motion sequence, without data acquisition, in order to
ensure that there are no collisions. Stop start, operating mode and override may
be used as required.
Measurement:
Execute the axis test with 100% override and NC automatic, no stop.
Function
Contour test
Measurement
Fig. 2-40: Measurement series of a test series
© Siemens AG 2012 All Rights Reserved
ePS Network Services, Function Manual (FH) - 03/2012
Description
A contour test can be run to check that the mea-
surement part program is collision-free before
actual measurement.
The contour test can also be carried out with the
function "single block execution" active.
Selection of the "Measurement type" tab. The
measurement can be performed once the notes
have been read and understood.
2 Machine Information
2.3 Test series on the machine
Type
ACTION
ACTION
2-69