Configuring Measurements And Measurement Series; Circularity Test - Siemens SINUMERIK Series Function Manual

03/2012

3.2 Configuring measurements and measurement series

Function description
Configuration of measurements and measurement series it when you define the
parameters required for measurement. The configurations created are always sto-
red with the measurements and can be used again to repeat the measurements.
That especially applies to measurement series. The configuration of a measure-
ment series ensures that measurements are made with the same settings every
time. This permits evaluation of the progression of characteristics over time.
In addition to parameters for performing a measurement, the limit values of the
characteristics are also configured. Limit values can be configured for measure-
ment series. The configuration is only possible on the PC. Individual measure-
ments that do not belong to a measurement series cannot have limit values.
Availability and privileges
On the operator panel, a measurement is configured or a measurement series con-
figuration changed only during the measurement procedure. On the operator panel,
it is only possible to create a measurement series based on a measurement being
performed.
On the PC, it is possible to configure measurement series. The authorization re-
quired to configure measurements and measurement series is described in detail in
the Appendix.

3.2.1 Circularity test

Parameter description
Parameters for conducting a circularity test:
Function
Name
Channel
Axis
Center Axis 1
Center Axis 2
Diameter
Feedrate
© Siemens AG 2012 All Rights Reserved
ePS Network Services, Function Manual (FH) - 03/2012
3.2 Configuring measurements and measurement series
Description
Name of the measurement series (meas-
urements do not have a name).
Selection of the required channel:
The channel defines the possible axis pairs
in the "Axes" selection list.
Selection from the possible pairs of geome-
try axes.
Specification of the center coordinates of
the circle for the first axis.
Specification of the center coordinates of
the circle for the second axis.
Diameter of the circle.
Path velocity of the circular movement.
3 Setting up functions
Type
INPUT
SELECTION
SELECTION
INPUT
INPUT
INPUT
INPUT
3-101