Suzuki SY413 Service Manual page 1768

5-74 BRAKES
[For vehicles not equipped with ABS]
[For vehicles equipped with ABS]
MASTER CYLINDER INSPECTION
WARNING:
1.8L engine RH model's brake master cylinder cannot be
disassembled. When any part of it other than primary pis-
ton as described in CAUTION above has been disas-
sembled, or when anything faulty is found in it, it must be
replaced as an assembly.
CAUTION:
1.8L engine RH model's brake master cylinder cannot be
disassembled in principle. Should primary piston have
come off from cylinder while dismounting or handling it,
wash it in the same specified fluid as that in reservoir
tank and place it back in cylinder.
INSPECT MASTER CYLINDER
Inspect all disassembled parts for wear or damage, and replace
parts if necessary.
NOTE:
D Wash disassembled parts with brake fluid.
D Do not reuse piston cups.
Inspect master cylinder bore for scoring or corrosion. It is best to
replace corroded cylinder. Corrosion can be identified as pits or ex-
cessive roughness.
NOTE:
Polishing bore of master cylinder with cast aluminum body
with anything abrasive is prohibited, as damage to cylinder
bore may occur.
Rinse cylinder in clean brake fluid. Shake excess rinsing fluid from
cylinder. Do not use a cloth to dry cylinder, as lint from cloth cannot
be kept from cylinder bore surfaces.