Suzuki SY413 Service Manual page 2161

7B1-108 AUTOMATIC TRANSMISSION
5) For removing coast clutch piston, install forward clutch assem-
6) Remove coast clutch piston with O-rings using compressed air
7) Remove O-rings from coast clutch piston.
1. Coast clutch piston
8) Remove overdrive clutch piston with O-rings using compressed
9) Remove O-rings from overdrive clutch piston.
1. Overdrive clutch piston
INSPECTION
1) Check that sliding surfaces of discs, plates and flanges are not
2) Measure height of overdrive clutch return spring.
3) Check to make sure that ball makes creaking noise when shak-
1. Ball
bly.
(400 – 800 kPa, 4 – 8 kg/cm
NOTE:
Never reuse O-rings after removal.
air (400 – 800 kPa, 4 – 8 kg/cm
(1).
NOTE:
Never reuse O-rings after removal.
worn or burnt. If necessary, replace.
NOTE:
D If disc lining is exfoliated or discolored, or part of printed
numbers ((1) section) is defaced, replace all discs.
D Before assembling new discs, soak them in A/T fluid for
at least two hours.
Specified value: 18.9 mm (0.74 in.)
NOTE:
Do not apply excessive force when measuring spring
height. Perform measurement at several points.
ing piston clockwise and counterclockwise. (i.e., check that ball
is free.)
2
, 57 – 113 psi) through oil hole (1).
2
, 57 – 113 psi) through oil hole