Suzuki SY413 Service Manual page 1507

3B1-10 POWER STEERING (P/S) SYSTEM
For vehicle equipped with A/C
Push
For vehicle not equipped with A/C
Push
1. P/S pump pulley
2. A/C compressor pulley
3. Crankshaft pulley
For vehicle equipped with A/C
For vehicle not equipped with A/C
POWER STEERING BELT
(1.3 L and 1.6 L engine models)
1) Detach air cleaner assembly from body and shift its position.
2) Check that belt is free from any damage and properly fitted in
3) Check belt tension by measuring how much it deflects when
4. Tension pulley
5. Water pump pulley
6. Generator
POWER STEERING BELT TENSION ADJUSTMENT
(1.3 L and 1.6 L engine models)
1) Remove engine under cover of right side and loosen tension
2) Adjust belt tension.
1. Tension pulley
(with groove)
2. Tension pulley
(without groove)
3. Tension bolt
4. Tension nut
5. Belt
: Tension
: Loosen
pulley groove.
pushed at intermediate point between P/S pump pulley and
crank pulley with about 10 kg (22 lb) force.
Deflection of P/S belt "a": 8 – 10 mm (0.32 – 0.39 in.)
nut.
With A/C equipped vehicles, turning tension bolt counterclock-
wise causes pulley to rise, increasing belt tension.
With A/C non-equipped vehicles, turning tension bolt clockwise
causes pulley to lower, increasing belt tension.
In both cases, turning tension bolt in the other way decreases
belt tension.
Be sure to tighten tension nut after adjusting belt tension.
Tightening Torque
.
(a): 45 N m (4.5 kg-m, 32.5 lb-ft)