Suzuki SY413 Service Manual page 2146

1. Reverse clutch assembly
2. 2nd and 4th brake band assembly
b) Plug oil hole (1).
c) Measure piston rod stroke while applying and releasing
compressed air (400 – 800 kPa, 4 – 8 kg/cm
from oil hole (2).
Specified piston rod stroke: 1.98 – 2.42 mm
NOTE:
If piston rod stroke exceeds above specification, adjust
piston rod (For detail, refer to step 23 on "INSTALLATION"
procedure.) or inspect band assembly of 2nd and 4th
brake for damage, wear or discoloration.
23) Pull out reverse clutch assembly.
24) Remove 2nd and 4th brake band assembly.
25) Remove straight pin.
Reference value of straight pin
Length: 45 mm (1.77 in.)
Outside diameter: 8 mm (0.31 in)
3. Straight pin
26) Apply valve lifter as illustrated and push in brake inner cover.
Special Tool
(A): 09916-14510
(B): 09916-48210
27) Remove snap ring by using snap ring plier (special tool).
Special Tool
(C): 09900-06108
AUTOMATIC TRANSMISSION 7B1-93
2
, 57 – 113 psi)
(0.078 – 0.095 in.)