Suzuki SY413 Service Manual page 2133

7B1-80 AUTOMATIC TRANSMISSION
1. Selector lever
("P" position and pushing knob button)
2. Key release cam
3. Selector bracket
4. Cable bracket nut
5. Leaf spring
1. Detent pin position when knob button is pressed
at "P" position.
3) Shift selector lever to "P" position and with lock plate manually
moved toward front side of vehicle, push knob button of selec-
tor lever.
4) Under above condition, fix key release cam inserting special
tool into holes on cam and selector bracket.
Special Tool
(A): 09925-78210 (6 mm)
5) Connect cable end to key release cam.
6) With cable bracket pushed in arrow direction by spring force,
tighten cable bracket nut.
Tightening Torque
(a): 13 N·m (1.3 kg-m, 9.5 lb-ft)
7) Remove special tool. Then with lock plate of shift lock solenoid
1. Knob button
2. Key release cam
manually moved toward front side of vehicle, check that key
3. Lock plate of shift
release cam moves smoothly by operating knob button of se-
lock solenoid
lector lever.
8) With selector lever set at "P" position, turn ignition key to "ACC"
position and then check for the following conditions.
9) Install steering column referring to Section 3C1.
10) Install steering column hole cover and steering joint cover.
11) Connect negative cable at battery and enable air bag system,
referring to "ENABLING AIR BAG SYSTEM" in Section 9J.
With knob button released, ignition key can be turned from
"ACC" position to "LOCK" position.
With knob button pressed, ignition key cannot be turned
from "ACC" position to "LOCK" position.