Suzuki SY413 Service Manual page 2196

1. Oil reservoir plate
2. Magnet
3. Retainer
4. Oil seal
1. Integrated needle roller bearing
TRANSMISSION HOUSING
REMOVAL
1) Remove oil seal.
NOTE:
Never reuse removed oil seal.
2) Remove oil reservoir plate with three magnets by removing
bolts.
3) Remove roller bearing retainer by removing bolt.
4) Remove cylindrical roller bearing, using special tools.
1. Cylindrical roller
bearing
Special Tool
(A): 09942-15511
(B): 09941-54911 (remover)
(C): 09921-26010 (coller)
NOTE:
Never reuse removed bearing.
5) Remove integrated needle roller bearing with race.
INSPECTION
Check pan for particles.
Remove magnets and use them to collect any chips.
Inspect oil reservoir plate for any chips and particle collected on
magnet.
Inspect them carefully to find out the type of wear on transmission.
Steel (magnetic)
Brass (nonmagnetic)
INSTALLATION
1) Apply A/T fluid to integrated needle roller bearing with race.
Race dimension
Outside diameter : 45.7 mm (1.80 in.)
Inside diameter
Thickness
2) Install integrated needle roller bearing to transmission case.
3) Apply A/T fluid to outer surface of cylindrical roller bearing.
4) Tap cylindrical roller bearing, using special tools.
Special Tool
(A): 09924-74510
(B): 09944-88210
AUTOMATIC TRANSMISSION 7B1-143
. . . . . . . . . Wear of bearing, gear and plate
. . . . . Wear of bush
: 30.0 mm (1.18 in.)
: 3.0 mm (0.12 in.)