Suzuki SY413 Service Manual page 2176

1. Reverse clutch drum
subassembly with bearing
2. Snap ring
1. Reverse clutch drum 3. Thrust washer
2. Sun gear input flange 4. Retainer ring
1. Thrust needle roller bearing
2. Thrust bearing race
3. Input shaft
6) Install clutch plates and No.3 clutch discs in the following or-
der.
(1) Plate " (2) Disc " (3) Plate " (4) Disc
NOTE:
Check to make sure that flat end section of plate faces to-
ward piston side.
7) Install sun gear input flange with retainer ring.
8) Measure pack clearance, referring to preliminary check in
"REVERSE CLUTCH"
9) Remove reverse clutch from oil pump body.
10) Remove sun gear input flange by removing retainer ring.
11) Coat race with thrust needle roller bearing with grease.
Grease:99000-25030 (SUZUKI SUPER GREASE C)
12) Install thrust needle roller bearing to input shaft.
Race with bearing dimension
Outside diameter : 31.1 mm (1.22 in.)
Inside diameter : 18.7 mm (0.74 in.)
Thickness : 2.6 mm (0.10 in.)
13) Coat thrust bearing race with grease.
Grease: 99000-25030 (SUZUKI SUPER GREASE C)
14) Install thrust bearing race to input shaft.
Race dimension
Outside diameter : 33.3 mm (1.31 in.)
Inside diameter : 21.7 mm (0.85 in.)
Thickness : 2.0 mm (0.08 in.)
AUTOMATIC TRANSMISSION 7B1-123