Activating Diagnostics Via The Control; Identification & Maintenance Data (I&M) - Siemens Sinamics G120P Operating Instructions Manual

6.3.5

Activating diagnostics via the control

The inverter provides the functionality to transfer fault and alarm messages (diagnostic
messages) to the higher-level controller according to the PROFIdrive error classes.
The functionality must be selected in the higher-level controller and activated by powering up.
6.3.6 Identification & maintenance data (I&M)
I&M data
The inverter supports the following identification and maintenance (I&M) data.
I&M
data
I&M0
I&M1
I&M2
I&M3
I&M4
When requested, the inverted transfers its I&M data to a higher-level control or to a PC/PG
with installed STEP 7, STARTER or TIA-Portal.
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
Format Explanation
u8[54] PROFINET Inverter-specific data, read only
Visible String [32] Plant/system identifier
Visible String [22] Location code
Visible String [16] Date
Visible String [54] Any comment
Octet String[54] Test signature for tracking
changes for Safety Integrated -
this value has no significance for
SINAMICS G120P Cabinet
This value can be changed by
the user.
The test signature is reset to the
value generated by the machine
is p8805 = 0 is used.
6.3 Communication via PROFINET
Associated Example for the
parameters content
- See below
p8806[0 ... 31] "ak12-
ne.bo2=fu1"
p8806[32 ... 53] "sc2+or45"
p8807[0 ... 15] "2014-05-21
12:15"
p8808[0 ... 53] -
p8809[0 ... 53]
Operation
181