Connect The Converter To Profinet; Configuring Communication To The Control - Siemens Sinamics G120P Operating Instructions Manual

6.3.2

Connect the converter to PROFINET

Connecting up
Connect the inverter (IO device) and your PG/PC (IO supervisor) via PROFINET cables with
the control. The maximum permissible cable length is 100 m.
See also Section: CU230P-2 PN Control Unit (option K96) (Page 72).
Figure 6-5
Recommended PROFINET connectors and pin assignment
We recommend the following connector with article number: 6GK1901-1BB10-2Ax0 for
connecting the PROFINET cable.
Instructions for assembling the SIMATIC NET Industrial Ethernet FastConnect RF45 Plug
180 can be found on the Internet under product information "Assembly instructions for
SIMATIC NET Industrial Ethernet FastConnect RJ45 Plug
(http://support.automation.siemens.com/WW/view/en/37217116/133300)".
Laying and shielding the PROFINET cable
Information can be found on the Internet: PROFIBUS user organization installation
guidelines (http://www.profibus.com/downloads/installation-guide/).
6.3.3

Configuring communication to the control

Loading GSDML
In order to establish communication between the inverter and controller via PROFINET, you
need the device file of the inverter "GSDML" for your controller. You can then configure the
communication.
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
Example: PROFINET in a line topology
6.3 Communication via PROFINET
Operation
179