Commissioning; Section Content - Siemens Sinamics G120P Operating Instructions Manual

Commissioning

5.1

Section content

This section provides information on the following:
● Pre-assignment of inputs/outputs and wiring for p0015 macros
● Initial commissioning of the cabinet drive (initialization) with IOP and STARTER
– Entering the motor data (drive commissioning)
– Entering the most important parameters (basic commissioning), concluding with motor
Important information prior to commissioning
Danger to life if the safety instructions and residual risks are not carefully observed
If the general safety instructions and remaining risks are not observed, accidents can occur
involving severe injuries or death.
• Observe the general safety instructions.
• When assessing the risk, take into account residual risks.
Danger to life as a result of incorrect or modified parameterization
As a result of incorrect parameterization, machines can malfunction, which in turn can lead
to injuries or death.
• Protect the parameterization (parameter assignments) against unauthorized access.
• Respond to possible malfunctions by applying suitable measures (e.g. EMERGENCY
The cabinet unit offers a varying number of internal signal interconnections depending on the
delivery condition and the options installed. For the inverter control to be able to process the
signals correctly, several software settings must be made.
During initial power-up of the Control Unit and during the initial commissioning, parameter
macros are executed and the necessary settings made.
The settings are documented in the Appendix.
After initial power-up, initial commissioning, and also following a "Parameter reset to factory
settings," individual parameter values deviate from the factory settings stated in the List
Manual.
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
identification
WARNING
WARNING
STOP or EMERGENCY OFF).
5
123