5
Clearing a source address setting
To clear a source address setting for a particular bit
In the Source Assign menu, select the serial tally port and bit number (see steps
2 and 3 in the previous item), then press [Clear].
This clears the source address setting for the selected bit.
To clear all source address settings
In the Source Assign menu, select the serial tally port, then press [All Clear].
A confirmation message appears.
• If you select "Yes," this clears all source address settings for the selected
• If you select "No," the clear operation is canceled.
350
Setup Relating to Router Interface and Tally
Press [Source Address Set].
This confirms the setting.
serial tally port.