Sony DVS-9000SF User Manual page 104

3
To display a test sphere
Use the following procedure.
1
2
Setting light sources
Up to three light sources (Light 1 to Light 3) for Spotlighting can be set by
menus.
Light source menu
The following three light source menus are available.
Light source
Light 1
Light 2
Light 3
Note
The BZS-9471 Texture Lighting Software (for BKDS-9470) or BZDM-9050
Texture Lighting Software (for MVE-9000) is required to enable Light 2 and
Light 3.
An install key must be entered to use the software (see page 241).
To set light source data
The following example shows how to set light source data with the Light 1
menu.
If you use multiple light sources, use the same procedure for all light sources.
1
104
DME Special Effect Operations
Press [Set].
The texture selected in step 2 appears in the list on the left of the status
area.
In the Spot Lighting menu, press [Test Sphere], turning it on.
A test sphere effect appears on the image surface.
Adjust the following parameter.
Knob Parameter Adjustment
5 Amp Distance of light
a) Light appears from Z direction. At –100.00 the light goes deepest, at +100.00 the whole
image is lit like a flat effect.
In the <Spot Lighting Adjust> group of the Spot Lighting menu, press
[Light 1].
Menu
DME>Light/Trail>Spot Lighting>Light 1
DME>Light/Trail>Spot Lighting>Light 2
DME>Light/Trail>Spot Lighting>Light 3
Setting values
a)
–100.00 to +100.00