To make link bus settings
For the link number selected in the External Bus Link menu, use the following
procedure.
1
In the Panel>Config>External Bus Link menu, press [Link Bus Adjust].
The Link Bus Adjust menu appears. The status area lists the current link
status, and the switcher bus names and router destinations that can be
selected.
In this menu too, you can use knob 1 to select the link to be set.
2
Using any of the following methods, select the switcher bus and the router
destination to be linked to the switcher bus.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob
2
3
3
To confirm the bus selected in step 2, press [Master Bus Set], and to
confirm the destination press [Linked Dest Set].
This confirms the selection, which is reflected in the status area.
Linking transitions between keyers
Use the following procedure.
1
In the Panel>Config menu, press [Key Trans Link].
The Key Trans Link menu appears.
The status area shows the keyers for each M/E bank and the linked keyers.
2
Using any of the following methods, select the keyer to be the master.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
The selected keyer appears in reverse video.
Parameter
Adjustment
Internal Bus
Switcher bus selection
Destination
Router destination selection
Parameter
Adjustment
Master Key
Select keyer to be master
Setup Relating to Operations From the Control Panel
Setting values
1 to 128
1 to 128
Setting values
1 to 16
253