1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at any keyframe within the range to be modified.
3
Carry out the necessary modifications.
4
Press the [FROM TO] button, turning it on.
The display in the numeric keypad control block shows the current
keyframe number, followed by "TO."
5
Using the numeric keypad in the numeric keypad control block, carry out
the following operations.
• To set the first keyframe in the range to be modified, press the [CLR]
button, then enter the keyframe number, and press the [ENTER] button
to confirm.
• To set the last keyframe in the range to be modified, enter the keyframe
number from the numeric keypad, and press the [ENTER] button to
confirm.
6
Press the [MOD] button. Alternatively, hold down the [SHIFT] button and
press the [MOD] button.
For the difference in the result, see "Differences in the changes when a
number of keyframes are modified" (page 169).
This makes the modification simultaneously to all keyframes in the
specified keyframe range.
Differences in the changes when a number of keyframes are
modified
When you select a number of keyframes to modify, and press the [MOD]
button alone or in combination with the [SHIFT] button, the result of the
operation differs as shown below.
Modifying the keyframes by pressing the [MOD] button alone
The modified parameter values are taken as absolute values, and applied to all
of the selected keyframes.
Creating and Editing Keyframes
169