Drive-Cliq Signal Cables Motion-Connect With Rj45 Plug And M12 Socket - Siemens Sinamics S120 Manual

Note
DRIVE-CLiQ cabinet bushing for RJ45 connectors
For information on the cabinet bushings, see Chapter DRIVE-CLiQ cabinet bushings
(Page 679).
12.8.1.4

DRIVE-CLiQ signal cables MOTION-CONNECT with RJ45 plug and M12 socket

The MOTION-CONNECT DRIVE-CLiQ signal cables with RJ45 plug and M12 socket have
24 VDC cores. They establish the connection between components with a DRIVE-CLiQ
connection and a direct measuring system equipped with DRIVE-CLiQ ASIC with 8-pin M12
connector. Measuring systems from third-party manufacturers can be directly connected to
the SINAMICS S120.
Basic cable
The pre-assembled basic cable has eight cores, of which four are used for data transmission
and two for the 24 V supply. It is used to convert from a RJ45 plug (IP20) to an M12 socket
(IP67).
Figure 12-23 DRIVE-CLiQ basic cable with RJ45 plug and M12 socket
Booksize Power Units
Manual, (GH2), 04/2014, 6SL3097-4AC00-0BP6
Cabinet design and EMC Booksize
12.8 Connection systems
733