Executing The Package On The Pcu 50 From The Network - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.11 Package execution
Note
In a PCU with Windows 7, various settings are required to permit package execution for
automated commissioning.
4.11.2.2

Executing the package on the PCU 50 from the network

Windows packages can be executed on the PCU 50. The package is on a network drive.
Preconditions
The following requirements apply:
● There must be a connection to the network drive.
● The folder containing the Windows package must be released for a user of the PCU 50
(default user "auduser") for read and write access.
● If the Windows package contains a restart of the PCU 50 (e.g. due to an installation), then
the PCU-local default user "auduser" and the password "SUNRISE" must be used.
Procedure
1. Transfer the project in Expert as Windows package.
2. Save the Windows package in a folder of the network drive.
3. Release the folder of the network drive for users of the PCU 50 (preferred default user
"auduser").
4. Let the PCU 50 start up in the Service Desktop.
Note
Do not start HMI Advanced or SINUMERIK Operate.
5. In the Windows Start menu, select "Start > Run".
6. Enter the following command: "\\<IP address or UNC name>\<share name>\<package
name>.
e.g.: \\10.8.6.16\Package folder\Machine_1.exe
7. Follow the instructions of the package dialogs.
See also
Executing a standard package (Page 318)
320
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD