Siemens SINUMERIK 840D sl Operating Manual page 319

The following is required for the execution of (Windows) packages that also access data of the
NCU:
● A network connection to NCU / PCU
● Create MyConfig NcuShareService
When executing a package, before establishing the connection to the NCU, a check is
made as to whether a sufficiently current version of Create MyConfig NcuShareService is
available on the Windows system.
If an insufficiently current version is found, the package execution installs a current version.
(This is a component of the package.)
While the package is being executed, with Create MyConfig NcuShareService, folder C:
\ProgramData\Siemens\UpNcuShare is released for sharing.
Once the package execution has been completed, the service cancels the share again.
NcuShareService
Service NcuShareService is required to execute CMC packages with an NCU component
involving Windows PC or PCU50. The service activates an exchange release (share) on the
Windows system for the duration of the package execution. There are three options for
installing the NcuShareService service on a Windows PC (PG or PCU):
1. Automatically during installation of CMC 4.7
2. Manual installation NcuShareService
3. After enabling of the service by configuration.
In Expert, when starting a CMC package, service NcuShareService is installed if it is does not
already exist - and can be also uninstalled again (this can be configured).
Starting to execute the package under Windows
Establish a network connection between the PC and the control devices (NCU7x0, PCU) that
is to be processed with the package.
The package generated by Expert for Windows with the file extension "exe" can be started on
the PCU, the PG or the PC using standard Windows resources ("Run...", double-click, etc.).
If the file is the only exe file in the folder "Install" of a USB medium inserted in the PCU (USB
FlashDrive, hard disk, CD), then the file is automatically started when the PCU is booted.
Note
Unknown USB medium
For older PCU-base systems, ensure that the USB medium is known to the PCU, as a new
medium is installed after the start routine for the package. This means that it may be necessary
to insert the USB medium and then switch-off and switch-on the PCU again after approximately
30 seconds.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
Create MyConfig - Expert
4.11 Package execution
319