Siemens SINUMERIK 840D sl Operating Manual page 296

Create MyConfig - Expert
4.7 Reference list, system variables
Enumeration installation modes - Mode
Range Enumeration
CNC software dialog - NcuSetup
Enumeration installation modes - Mode
Up.$Dialog.NcuSetup.Modes.
INSTALL
NONE
UPDATE
Enumeration source of the NC data - NcSource
Range Enumeration
System configuration dialog - SystemConfig
Enumeration source of the NC data - NcSource
Up.$Dialog.SystemConfig.NcSources.
ARCHIVES
FACTORY
ORIGIN
Enumeration source of the PLC data - PlcSource
Range Enumeration
System configuration dialog - SystemConfig
Enumeration source of the PLC data - PlcSource
Up.$Dialog.SystemConfig.PlcSources.
ARCHIVES
FACTORY
ORIGIN
Enumeration source of the SDB data - SdbSource
Range Enumeration
Dialog, system configuration - SystemConfig
Enumeration source of the SDB data - SdbSource
Up.$Dialog.SystemConfig.SdbSources.
296
Type
Enumerator value
Type
Enumerator value
Type
Enumerator value
Type Change effective
Change effective Description
readOnly Installations mode, new installation
Installation mode without installation
Installation mode upgrade
Change effective Description
readOnly The data are taken from an archive.
These standard NC data are used after
a general reset
The actual NC data - at the time that
the package is executed - are used.
Change effective Description
readOnly The data are taken from an archive.
These PLC data are used after a gen‐
eral reset
The actual PLC data - at the time that
the package is executed - are used.
Description
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD