Table of Contents
Advertisement
Re-assigning
an Equipment
Label
The following instructions enable you to reassign an equipment label from a lost
device to a replacement transceiver.
If the leadset is attached during this procedure, the label assignment will
Note—
fail.
Step
Action
1
At the Information Center, clear the sector that the original
Equipment Label was assigned to. (Patient Window -> Sector
Setup -> Clear Sector -> OK).
Ensure that no patient is being monitored by the original
Note—
(lost) device before clearing the sector.
Select All Controls, then Label Assignment.
2
3
Enter password.
The remaining screens will be in English only.
Note—
4
Insert batteries into the replacement device, and remove the leadset,
if present.
All transceiver indicators should flash, and you should hear a double
tone repeated every 3 seconds, indicating that the transceiver has no
Equipment Label.
5
Select Refresh.
6
Select the MAC address of the replacement device from the "New
Devices" list.
The transceiver MAC address is located inside the battery
Note—
compartment.
7
Select the Equipment Label that was assigned to the unit's previous
device from "Equipment Labels" list.
Maintenance, Cleaning & Troubleshooting
Maintenance
11-3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
