Displaying
Pulse Rate
Displaying
Pleth Wave
When
Connected
to TeleMon
Step
Action
3
After approximately 15 seconds, the value, with the measurement
time, is displayed at the Information Center.
There are no sounds associated with continuous SpO
Note—
measurement.
4
To discontinue SpO
the Information Center.
If the sensor is removed without discontinuing SpO
Note—
monitoring in the Telemetry Setup Window at the Information
Center, an SpO
Silencing this technical alarm will turn the SpO
When operating in Continuous mode, you can view the Pulse rate at the
Information Center. See "Patient Configurable Settings in Telemetry Setup" on
page 9-4.
If Pulse rate is turned on, the Patient Sector and Patient Window of the
Note—
Information Center display the parameter label with "T" (for example,
"PulseT") to indicate that the measurement was made via telemetry.
The transceiver can be configured to transmit the Pleth wave for display at the
Information Center. See "Patient Configurable Settings in Telemetry Setup" on
page 9-4.
When the transceiver is connected to TeleMon:
•
The SpO
measurement mode is always Continuous.
2
monitoring, uncheck the Enable SpO
2
T NO SENSOR technical alarm will result.
2
Measuring SpO
2
box at
2
2
measurement off.
2
8-17
SpO
Monitoring
2
2