Mps Options - Samsung OfficeServ 7000 Series Programming Manual

Call server
Hide thumbs Also See for OfficeServ 7000 Series:
Table of Contents

Advertisement

[843] MPS OPTIONS

This MMC provides network configuration of MPS (Media Proxy Server) in the system.
This option can be shown in some OfficeServ system.
No
Parameter
0
LOCATION
1
IP ADDRESS
2
GATEWAY
3
SUB MASK
4
IP TYPE
5
LOCAL RTP
6
CARD RESET
7
PUBLIC IP1
8
PUBLIC RTP1
9
PUBLIC IP2
10
PUBLIC RTP2
11
PUBLIC IP3
12
PUBLIC RTP3
13
IP VERSION
If MP-MPS (the embedded MPS) is selected, parameters such as IP ADDRESS,
GATEWAY, SUB MASK, CARD RESET can not be set in this MMC because
these parameters and the system values are the same.
The system values can be referred in MMC 830.
CONDITIONS
This MMC cannot be accessed unless MMC861 MPS SERVICE is enable.
© SAMSUNG Electronics Co., Ltd.
OfficeServ 7000 Series Call Server Programming Manual
Located Cabinet and slot number of MPS.
Specifies the IP address for the MPS.
Specifies the designated IP gateway address used for contacting IP
devices beyond the local subnet.
Specifies the IP subnet mask. This parameter is used by the system to
calculate the range of IP devices (subnet) that are within 'direct reach' of the
MPS. (without having to go through the designated network IP gateway)
Specifies if the system will be routing data over a public or private
network.
Local RTP Port
Reboots MPS
Pulbic IP Address is only used for VoIP signaling protocols in a NAT
network . NAT system binds IP Address with Public IP and processes a
voice stream. See System IP Type on MMC 830
Public RTP Port which NAT system binds a private RTP port with
Pulbic IP Address is only used for VoIP signaling protocols in a NAT
network . NAT system binds IP Address with Public IP and processes a
voice stream. See System IP Type on MMC 830
Public RTP Port which NAT system binds a private RTP port with
Pulbic IP Address is only used for VoIP signaling protocols in a NAT
network . NAT system binds IP Address with Public IP and processes a
voice stream. See System IP Type on MMC 830
Public RTP Port which NAT system binds a private RTP port with
Specifies MPS IP version is IPv4 / IPv6.
Description
2-401

Advertisement

Table of Contents
loading

Table of Contents