Options; H.323 Options - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[834] H.323 OPTIONS

This MMC provides various VoIP support options. The options set in this MMC apply
system wide.
MMC [834]
This program may not be available in certain OfficeServ models.
No Parameter
00 GATEWAY CALL ID
01 H.323 FAST SETUP
02 CALLER ID TYPE
06 TUNNELING
07 DEFAULT DIL NO
11 CODEC AUTO NEGO
14 SIGNAL PORT
17 SEND CLIP TABLE
18 INCOMING MODE
2-368
Description
Numeric identifier for system (up to 12 digits)
Enables or disables the H.323 Fast Start call setup
method.
This option controls the calling party identification
type. There are 3 possible selections:
0 GWID: shows the gateway call ID.
1 ANI: shows the calling station number
2 IP: shows the calling H.323 gateway IP
address.
Enables or disables the need for additional
channels using H.245 Signaling. Tunneling allows
use of the H.245 signal channel with the Q.931
channel.
This allows programming of the default direct-in-
line number when digits are missing or incorrect on
an inbound call.
Enables or disables Auto CODEC Negotiation
when the MGI is used as an H.323 gateway.
Indicate the port number for H.323 Signaling and
sets a range of numbers allowed by firewall
equipment. The common and default IP path or
port used is 10000.
Refers to SEND CLI NUMBER (MMC 323), which
provides calling party identification when using the
MGI as a H.323 gateway. This provides station ID
of the calling station. A single-digit value
corresponding with the desired table in MMC 323
should be entered here. This is only used when
MMC 405 value is null.
This option selects how incoming calls are routed
when the MGI is used as a H.323 gateway.
0 FOLLOW TRUNK RING: Follows MMC 406
1 FOLLOW DID TRANS: Follows MMC 714
2 FOLLOW INCOM DGT: Follows MMC 724
Default
1234
ENABLE
ANI
ENABLE
500
ON
10000
1
FOLLOW
DID TRANS
© SAMSUNG Electronics Co., Ltd.