Video Signal Related Settings - Sony AWS-G500 Operating Instructions Manual

Video Signal Related Settings

Assigning video input signals to the selection buttons
These are preparations for handling video signals with the unit.
Assign video signals to the selection buttons 1 - 6 (PGM selection and NEXT
selection buttons).
Note
You can confirm assignments and information on input signals using each of the
corresponding ACCESS menus. The signal names displayed in the menus are
those of signals that are capable of being accepted as determined by the unit. Not
all standard signal names are displayed.
1
Press the MENU button.
2
In the top menu, select [Video Input Assign].
3
From the list select the number of the selection button, and confirm, then set
the following items in the submenu.
Assigning a name for the video
Assign a name for the video. The name assigned here appears in the source
viewer with the same number as the selection button.
1 Select [Source Name], and confirm; 2 enter the name in the input box,
and confirm.
1 Source Name
2 Input
3 Source Aspect
4 Control
5
6
Specifying a video input connector
Specify the video input connector to which the video signals assigned to the
selection button are input.
1 Select [Input], and confirm; 2 select the video input connector from the
list, and confirm.
1 Source Name
2 Input
3 Source Aspect
4 Control
5
6
1 2
[ ]
CAM1
S1-1 Composite
4:3
Off
1 2
No Assign
S1-1 Composite B SLOT1 IN1 Composite
4:3 S-Video
Off DV
SLOT1 IN2 Composite
S-Video
DV
SLOT2 IN1 Composite
S-Video
DV
SLOT2 IN2 Composite
S-Video
DV
SLOT3 IN1 RGB
SLOT3 IN2 RGB
Settings Related To Input Signals
Enter up to 20 characters.
* The source viewer can only
display a limited number of
characters.
67