Applying Filters To The Program Output Video; Adjusting The Audio Input Signal Levels - Sony AWS-G500 Operating Instructions Manual

Applying Filters to the Program Output Video

Adjusting the Audio Input Signal Levels

218 Video/Audio Signal Adjustments and Settings
Adjust this setting when the program output video appears blurry or the picture
flickers.
1
Press the MENU button.
2
In the top menu, select [Video Output].
3
1 Select [Filter Mode], and confirm; 2 select [SD Video] or [RGB] from
the submenu, and confirm; 3 select [Soft], [Normal] (when [SD Video] is
selected), or [Sharp], and confirm.
1
PGM OUT NTSC/60Hz SD Video
PGM OUT Aspect 4:3 RGB
PGM OUT Level
DV OUT
RGB OUT SXGA (60Hz)
Add TC
Add Aspect ID Off
Filter Mode
Caution
When [SXGA] or [WXGA] is selected for the RGB output signal format
setting, you cannot apply a filter.
Notes
• Select [Sharp] when the picture is blurry and [Soft] when the picture
flickers.
• When [Video RGB] is selected for the RGB output signal format setting,
the [SD Video] filter settings is applied.
You can adjust individual channels of the audio signals input to this unit.
1
Press the ACCESS button for the channel fader to which the audio you want
to adjust is assigned.
2
1 In the top menu, select [Input Trim]; 2 adjust with the sliders.
1
Chroma Level 100%
˚
Hue 0
Auto Gain Control On
Input Trim 0dB
Filter
EQ Off
3
Press the ESC button to close the ACCESS menu.
Note
You can also close the menu by pressing the same ACCESS button again.
2 3
Soft B Soft
Sharp Normal
Sharp
2