Cable Holder Removal; Figure 5-13: Inner Door Panel Removal; Figure 5-14: Cable Holder Removal - Miele G 600 Series Technical Information

Technical Information
Outer door panel:
1. Remove the GDU or custom panel.
2. Open the appliance door.
3. While supporting the outer door panel, remove the six (6) screws from the inside
edge of the panel.
4. Lower the panel to remove.
Inner door panel:
1. Remove the control panel. Refer to Section 5.47.
2. Remove the mounting bracket. Refer to Section 5.48. Components (e.g.,
electronic, handle) can remain on the mounting bracket.
3. Remove the insulated matting between the inner and outer door panels.
4. Remove the combination dispenser. See Section 5.8.
5. Remove the lock assembly. Refer to Section 5.12.
6. Remove the fan (if applicable). See Section 5.9.
7. Disconnect the ground wire.
8. Remove the screws (Figure 5-13, Item 3).
9. Open the door. Remove the raised-head screws (Figure 5-13, Item 4).
10. Remove the inner door panel in an upward direction.

Figure 5-13: Inner Door Panel Removal

5.11

Cable Holder Removal

1. Remove the door outer panel. See Section 5.10.
2. Open the cable holder cover with a screwdriver.
3. Remove the raised-head screw (Figure 5-14, Item 1).
4. Remove the cable holder.

Figure 5-14: Cable Holder Removal

54
G 600/G 800