Accessing Fault Codes; Deleting Stored Fault Codes; Program Index; Table 6-5: G 841, G 841 Plus, G 842 Fault Code Chart - Miele G 600 Series Technical Information

G 600/G 800
6.8.1.3.1

Accessing Fault Codes

1. Access Service Mode 2.
2. Turn the program selector switch to the 1 o'clock position.
3. Press the Start button once, then turn the selector switch slowly clockwise until the Start
light lights up.
4. Use the fault chart (Table 6-5) to determine which fault has been stored in the
dishwasher.
5. Turn the dishwasher off.
Selector switch position
1 o'clock
2 o'clock
3 o'clock
4 o'clock
5 o'clock
6 o'clock
7 o'clock
8 o'clock
9 o'clock
10 o'clock

Table 6-5: G 841, G 841 Plus, G 842 Fault Code Chart

6.8.1.3.2

Deleting Stored Fault Codes

Access Programming Mode and turn the dishwasher off.
6.8.1.3.3

Program Index

1. Access Service Mode 2.
2. Turn the program selector switch to the 2 o'clock position. The Start light flashes.
3. Press the Start button once, then turn the program selector switch slowly clockwise until
the Start light lights up. The program selector switch position will determine the
corresponding program index, as shown in Table 6-6 below.
4. Turn the dishwasher off.
Program selector position
1 o'clock
2 o'clock
3 o'clock

Table 6-6: G 841, G 841 Plus, G 842 Program Indices

Fault code Fault
F00 No error
F01 NTC or NTC connections open-circuited
F02 NTC or NTC connections short-circuited
Electronic failure, selector switch position not
F03
found
Heating failure - heating circuit opened or
F04
defective electrical component in heating circuit
F05 Water drainage failure, heater level switch
Too few pulses at flow meter / start of water
F06
intake
Too few pulses at flow meter / end of water
F07
intake
F08 Water intake failure, heater level switch
Heater level switch not switching on at the end
F09
of thermal stops
Program index
P0
P1
P3
85
Technical Information
Electronic version
EPLG 540
For future modifications
For future modifications