Test Program; Service Mode 2; Accessing Fault Codes; Table 6-37: G 890 Service Mode 2 Functions - Miele G 600 Series Technical Information

Technical Information
6.8.7.2.1

Test Program

The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access Service Mode 1.
2. Press the Economy button then press the Start/Stop button. The test program will start
and advance automatically.
3. Pressing the Start/Stop button repeatedly will allow the technician to advance through
the program. If the Start/Stop button is not pressed, the program will run automatically.
6.8.7.3

Service Mode 2

Service Mode 2 is used to change programmed functions and to access fault codes.
Programmed functions include operating hours, setting the flow meter, increasing the
water temperature, turning on or off the water softener, increasing water intake,
adding an interim rinse, and increasing the circulation fan time.
1. To access Service Mode 2, close the door and turn the dishwasher on. All
program lights should light. If not, press the Start/Stop button to cancel the
program. Turn the dishwasher off.
2. Press and hold the Top solo and Start/Stop buttons while turning the
dishwasher on. Successful accessing of Service Mode 2 is indicated by a dot (.)
in the display and flashing Drain and Salt lights.
3. Press the appropriate program button indicated in Table 6-37 to modify the
corresponding function.
4. Use the Top solo button to toggle through the function settings.
5. To save: Press the Start /Stop button twice and turn the dishwasher off.
Program button
Normal 150
Normal 130
Light Wash
Intensive
Energy Saver
Pots & Pans
Economy

Table 6-37: G 890 Service Mode 2 Functions

1
Factory setting
6.8.7.3.1

Accessing Fault Codes

1. Access Service Mode 2.
2. Press the Normal 150° program button.
3. The fault code will be shown in the display, e.g., F01, F02, etc.
4. Use the fault chart (Table 6-38) to determine which fault has been stored in the
dishwasher.
5. Turn the dishwasher off.
Function
Fault codes
Operating hours
Operating hours
Flow meter
Increase temperature
Water softener
Increase water level
106
Options Display
- F00, F01, etc.
- e.g., 001
- e.g., 127
195 to 205 195 to 205
150°F 50
160°F 51
1
With 60
Without 61
1
Standard 70
Increased 71
G 600/G 800