G 898; Programming Mode; Table 6-62: G 898 Programming Flow Chart; Table 6-63: G 898 Programming Functions - Miele G 600 Series Technical Information

Technical Information
6.8.12

G 898

Enter Programming Mode
Enter Service Mode 1
Enter Service Mode 2

Table 6-62: G 898 Programming Flow Chart

6.8.12.1

Programming Mode

1. To access the programming mode, close the door and turn the dishwasher on.
All program lights should light. If not, press the Start/Stop button to cancel the
program. Turn the dishwasher off.
2. Press and hold the "+" and Start/Stop buttons while turning the dishwasher on.
Successful accessing of the programming mode is indicated by a blinking Salt
light and P00, P01, etc., in the display, depending on the electronic version.
4. Press the appropriate program button indicated in Table 6-63 to modify the
corresponding function.
5. Use the Top solo button to toggle the functions on or off.
6. After selecting options, press the Start/Stop button twice and turn the
dishwasher off.
Program button
Sani Wash
Rinse & Hold

Table 6-63: G 898 Programming Functions

1
If "0" is displayed, the dishwasher is programmed for "without water softener". To change to "with
water softener", follow the steps in Service Mode 2 (Section 6.8.12.3).
2
Factory setting
3
Use 36 gpg for setting water hardness of 36 to 70 gpg.
Programming Flow Chart
To access:
Water hardness settings
Extended drying fan time (+14 minutes)
To access:
Manual step mode
Component test program
To access:
Error messages
Program index
Increased water temperature selection
Water softener (with/without)
Interim rinses
Extended water intake
Extended fan time (+45 minutes)
EGS
Function
Water hardness
setting
Extended drying time
(+14 min)
122
Options
1
0 gpg
2 3
1 - 36 gpg
2
4 min
14 min
G 600/G 800
Display
1
0
1 - 36 gpg
90
91