Middle Spray Arm Feed Pipe Removal; Flow-Through Heater Removal; Figure 5-19: Flow-Through Heater Assembly - Miele G 600 Series Technical Information

Technical Information
5.20

Middle Spray Arm Feed Pipe Removal

1. Remove the spray arm cover. See Section 5.19.
2. Remove the left side panel. See Section 5.3.
3. Remove the spring clip located at the top of the feed pipe near the flow-through
heater.
4. Lift upward on the feed pipe to remove.
Note:
When re-installing, ensure that the seal is installed on the feed pipe before
reinstallation.
5.21

Flow-Through Heater Removal

1. Remove the left side panel. See Section 5.3.
2. Fold up the insulation as needed.
3. Disconnect the heater electrical connections.
4. Disconnect the top and bottom hose connections.
5. Lift upwards on the heater assembly (Figure 5-19, Item 2) to release it from the
retainer.

Figure 5-19: Flow-Through Heater Assembly

Note:
When replacing a flow-through heater, the old seal (Figure 5-19, Item 1) should be
replaced as well.
58
G 600/G 800