NEC NEAX 2000 IVS Command Manual page 255

CM50
COMMAND CODE
50
4. DATA TABLE:
YY
CODE
00 0 Two leading digits to be added
3 Access Code to be sent out before a Mail Box Number
4 Access Code to be sent out after a Mail Box Number
5 Primary digit of 5 digits station
01 0 Effective data in CM35 YY = 15
1 LDN 0 ATTCON key (Data 00 in CM90)
8 LDN 7 key (Data 07 in CM90)
02 0 Effective data in CM35 YY = 15
1 TIE 0 key (Data 40 in CM90)
8 TIE 7 key (Data 47 in CM90)
05 00 Local Office Code Table Nro. 00
14 Local Office Code Table No. 14
Note 1: CM35 YY = 17 allows digits to be added or deleted from indialed digit streams on a route basis.
Note 2: "C" or "D" should not be assigned as the first characters of an access code to insert a prepause
timing. The prepause timing should be assigned with CM41 YY=0 Function No. 44.
Note 3: If "C" is inserted in the access code, it can be used as a pause (1.5 sec). To provide a program-
mable pause, insert "D" instead of "C". (Programmable pause; CM41 Y=0, Function No.38)
Note 4: Data set by this command is overridden by data set in CM58.
Note 5: These numbers should be different from any number assigned by CM10 and CM11.
CHAPTER 3
Page 218
Revision 2.1
TITLE:
COMMON ROUTE INDIAL
KIND OF DATA
MEANING
ND-45669 (E)
Addendum-001
AUGUST, 1998
SETTING DATA
DATA
XX
Note 1
XX
Note 2
XXXX
NONE
X
XX
XXXX
Note 4
XX
XXXX
Note 4
X . . . . .X
(Max. 12
digits)
Initial Data
:
MEANING
Digits to be added
Access Code to be sent out
to a VMS
X: 0 – 9, A (*), B (#), C/D
(Pause)
Note 3
Not to be sent out
Dialed number
Note 5
Dialed number
Note 5
Local office code