NEC NEAX 2000 IVS Command Manual page 108

COMMAND CODE
08
BASIC SERVICE FEATURE
378 Centralized Billing-CCIS feature for local office
379 Maximum number of dialed digits sent to CCIS network
(Tandem calls over 16 digits and name display)
380 Interval of ringer until detecting a ringing frequency from the
Main PBX (Centrex). (Ringing is sent from Multiline Termi-
nal until detection of the ringing frequency.)
381 Interval of ringer until detecting a ringing frequency PBX
(Centrex). (Ringing is sent from Multiline Terminal until de-
tection of the ringing frequency.)
Effective only when the 2nd data of CM08 - 380 is 0.
382 Lamp indication of Multiline Terminal until detecting the
kind of incoming call from Main PBX (Centrex). (Lamp is lit
until detection of ringing frequency.)
386 Allow or restrict ability to set Call Forwarding-All Calls/Busy
Line/No Answer-Outside or Split Call Forwarding-All Calls/
Busy Line/No Answer-Outside
387 The Call Forwarding-All Calls/Busy Line/No Answer-Out-
side or Split Call Forwarding-All Calls/Busy Line/ No An-
swer-Outside feature checks the trunk restriction class of the
forwarded station.
388 Holding/held party control for music on hold Tenant basis.
390 Multiline Terminal Tone Ringer Selection.
391 Lamp Indication on Multiline Terminal
400 Sending out of Calling Party Subaddress to ISDN network.
401 Terminating System for Called Party Subaddress.
403 Timing start when making an ISDN call from an ATTCON.
TITLE:
BASIC SERVICE FEATURES
ND-45669 (E)
0 To provide (for local office)
1 Not provided (for centralized office,
INITIAL
MP Reset)
0 24 digits
1 16 digits
0 As per the data CM08-381
1 As per the data CM35 YY=33
0 No Ringer
1 Ringing Tone (0.5 sec.) is sent once.
0 Red Steady Light
120 IPM Flash (As per the data CM35
1 YY = 32)
0 Restricted
1 Allow
0 This feature follows setting station
class
1 No check
0 Held party control (tenant)
1 Holding party control (tenant)
0 By pressing
1 By System Data (CM15 - 83, 94,
INITIAL
CM35-34)
0 Special
1 Standard
INITIAL
0 To send
1 Not sent
0 Station Call
1 Terminating system assigned by
CM30 YY = 02/03
0 Not available
1 Available
Initial Data
:
SETTING DATA
key and dialing 3
FNC
Note 3
Note 4
CHAPTER 3
Revision 2.0
CM08
Page 85