NEC NEAX 2000 IVS Command Manual page 154

COMMAND CODE
20
MAT
1. FUNCTION:
Trunk routes and features are assigned access codes. Required developments (Route Advance, Tenant,
Kind of Calling Terminal and Closed Number data) and trunk routes or features are assigned access
codes with CM22, CM23, CM24 and CM26. The following figure shows the relationship between com-
mands:
Numbering Plan Group
For each
Tenant
CM29 CM20
(4 groups)
2. PRECAUTION:
(1) This command is included in MAT mode menu "E7" (Numbering Plan [COM03]).
(2) If "7XX" (XX=20-83) is displayed when reading out the assigned data for the access code, the
access code which was entered is the leading digit(s) of another access code consisting of more dig-
its. Add a digit to the entered access code and try again (to determine the other access code). Then
decide which one to use or delete/change (not enough digits entered).
(3) If "WRONG" is displayed when reading out the assigned data for the access code, another access
code already exists with the same leading digits. Delete the last digit and try again (to determine the
other access code). Then decide which one to use or delete/change (too many digits entered.)
[CM20] Numbering Plan
TITLE:
NUMBERING PLAN
For each access code
Sta. No.
Access Code for Feature
Trunk Route
Closed Number Block
Trunk Route
CM26
(32 blocks)
CM23
(24 blocks)
(20 blocks)
ND-45669 (E)
Addendum-001
AUGUST, 1998
Numbering Plan
Tenant Block
For each Tenant
Access Code for Feature
Trunk Route
Terminal Block
For each ordinary Sta.
Trunk Route
CM24
Special Terminal Block
Trunk Route
CM25
For eack ordinary Sta. or data Sta.
(16 blocks)
CM20
Route Advance Block
Trunk
Route
CM22
Route
Advance
(32
Block
blocks)
CHAPTER 3
Page 129
Revision 2.1