NEC NEAX 2000 IVS Command Manual page 188

COMMAND CODE
31
MAT
Y
DATA
2 0 AP Number 0
3 AP Number 3
Note: AP Number (0 – 3) correspond to the
AP Number 0: Slot Number X
AP Number 1: Slot Number Y
AP Number 2: Slot Number Z
AP Number 3: Slot Number W
(X<Y<Z<W)
3 00 Assignment of signal pattern received from T1
network
A 14 Number of digits to be deleted from ANI
16 Sending of ACK-WINK signal to DTI on
receiving MF signal
17 Signal kind of Called Number sent from T1
network
18 Sending of ACK-WINK signal to DTI on
receiving DP signal
B 05 Supervisory timer of interdigital pause on
incoming call
Note 1: When the signal pattern from T-1 network is FGD format, assign the data to "None". When the
signal pattern from T-1 network is ANI format, assign the data to "02".
Note 2: When the signal pattern from T-1 network is FGD format, assign the data to "0". When the signal
pattern from T-1 network is ANI format, assign the data "1".
Note 3: When the signal pattern from T-1 network is FGD format, assign the data to "1". When the signal
pattern from T-1 network is ANI format, assign the data to "1". When the signal pattern from T-
1 network ANI format, assign the data "0".
TITLE:
SYSTEM ATTRIBUTE DATA
1ST DATA
MEANING
Slot Numbers assigned by CM05 as
shown below.
ND-45669 (E)
DATA
0 Designation of MF/Caller ID
Receiver/911 Sender to each circuit
3 (No. 0–3)
INITIAL
NONE ANI + Called Number
01 Called Number + ANI
02 ANI
INITIAL
03 Called Number
NONE No digit deletion
00 No digit deletion
01 Leading one digit deletion
10 Leading 8 digits deletion
0 To be sent
1 Not to be sent
0 DP
1 DTMF
0 To be sent
1 Not to be sent
NONE 24 sec.
01 1 sec.
INITIAL
31 31 sec.
Initial Data
:
2ND DATA
MEANING
DATA RECEIVER
0 No. 0–3 as Sender
1 No. 2, 3 as Receiver
2 No. 0, 1 as Receiver
3 No. 0-3 as Receiver
Note 1
Note 2
Note 3
Note 3
CHAPTER 3
Page 159
Revision 2.0
CM31