Table of Contents
Advertisement
9.1.8 +CCFC Call forwarding number and conditions
Command
execute
+CCFC=<reason>,
<mode>,<number>,
<type>,<class>,
<subaddr>,
<satype>,
<time>
test
+CCFC=?
Optional. 07.07 section 7.10. Controls call forwarding supplementary services. <reason>
values 4 and 5 are only applicable for <mode>=0. When the status request response from
the network indicates that SS is active for specific data bearer services (e.g. 'circuit async'),
AT interface shall indicate 'data circuit async' (<class>=32) ('not active' case is displayed
only when SS is not active to any service; i.e. +CCFC: 0,7). Supported <class> values: 1, 2,
4, 5, 7, 8, 12, 13, 15, 16, 32, 64, 128, 144, 160, 240, 242 and 255.
Note: <type>: 129, when ISDN numbering plan / 145, when International number
and ISDN numbering (in overall: could be between 128 and 255). See GSM 04.08
chapter 10.5.4.7 for other possible values.
Note: <satype>: "user specified". See GSM 04.08, ch. 10.5.4.8 for possible
values.
9.1.9 +CCWA Call waiting
Command
set
+CCWA=<n>,<mode>,<class>
read
+CCWA?
test
+CCWA=?
Optional. 07.07 section 7.11. Controls call waiting supplementary service and presentation of
+CCWA unsolicited result code. When the status request response from the network indicates
that SS is active for specific data bearer services (e.g. 'circuit async'), AT interface shall only
indicate 'data' (<class>=2) ('not active' case is displayed only when SS is not active to any
service; i.e. +CCWA: 0,7).
Parameters:
<n>
(sets/shows the result code presentation status in the TA):
0
disable
1
enable
<mode>
(when <mode> parameter is not given, network is not interrogated):
0
disable
1
enable
2
query status
<classx>
is a sum of integers each representing a class of information (default 7 equals
to all classes):
Response
when <mode>=2:
+CCFC: <status>,<class1>[,<number>,<type>
[,<subaddr>,<satype>[,<time>]]]
[<CR><LF>+CCFC: <status>,<class2>[,<number>
,<type>[,<subaddr>,<satype>[,<time>]]]
[...]]
+CCFC: (0-5)
Response
when <mode>=2:
+CCWA: <status>,<class1>
[<CR><LF>+CCWA: <status>,<class2>
[...]]
+CCWA: <n>
+CCWA: (0,1)
Default
+cme error
x
[,,,
see Note
#1,7
,,see
Note
#2,20]
Default
+cme error
x
0[,,7]
66/113
Advertisement
Table of Contents
