Q Result Code Suppression; Dce Response Format; Result Code Selection And Call Progress Monitoring Control; C Circuit 109 (Received Line Signal Detector) Behaviour - Nokia D211 Developer's Manual

6.3.5 Q Result code suppression

Command Description
set transmit codes
Q[0]
suppress codes
Q1
Mandatory. V.25ter section 6.2.5. Affects only result codes, not information responses.
6.3.6 V DCE response format
Command Description
set numeric V.25ter basic syntax result codes, limited headers and
V[0]
trailers
verbose V.25ter basic syntax result codes, full headers and trailers
V1
Mandatory. V.25ter section 6.2.6. For numeric result code values refer V.25ter section 5.7.1
and D, A and O commands in this document. Command S3 and S4 settings affect
header/trailer formatting. Note that result codes defined in GSM 07.07 and 07.05 have only
verbose values.
6.3.7 X Result code selection and call progress monitoring control
Command Description
set OK, CONNECT, RING, NO CARRIER, ERROR codes enabled
X[0]
also CONNECT 1200, CONNECT 2400 enabled
X1
same as value 1
X2
also BUSY enabled
X3
also NO ANSWER enabled
X4
also CONNECT 4800 (or higher data rates), DELAYED, BLACKLISTED enabled
X5
Mandatory. V.25ter section 6.2.7. When BUSY, NO ANSWER, DELAYED or BLACKLISTED is
not enabled, NO CARRIER is used instead. When CONNECT <rate> with a correct data rate
is not enabled, a plain CONNECT is used instead. Also GPRS context activation is indicated
by CONNECT. This command does not affect the presentation of other result codes than the
ones mentioned in the table above.
6.3.8 &C Circuit 109 (received line signal detector) behaviour
Command Description
set always on
&C[0]
normal operation
&C1
Mandatory. V.25ter section 6.2.8. Also known as DCD or carrier signal.
41/113