Table of Contents
Advertisement
<dial-string>
characters
V.25ter dialling digits
V.25ter modifiers
V.25ter semicolon
GSM 07.07 modifiers
de facto
any other character
See also 07.07 section 6.2 and V.25ter sections 6.3.1.1-6.3.1.7. Note that I is the only case-
sensitive dial string character.
Direct dialling command
D><str>[i/I][G][;]
D>mem<n>[i/I][G][;]
D><n>[i/I][G][;]
Direct dialling support is optional. 07.07 section 6.3.
Request GPRS service 'D'
D*99[*[<called_address>
][*[<L2P>][*[<cid>]]]]#
Optional. 07.60 section 10.4.1.1.
Note: GPRS Phase 1 does not support mobile originated context modification
Values
Description
accepted as valid digits
0123456789+*
accepted but ignored
#ABCD
in case of voice call: originate call to the number preceding comma,
,
wait for remote answer, pause for length specified with S8 register,
and send numbers after comma as DTMF digits; further commas
cause pause for length specified with S8 register (all commas are
ignored in case of data call)
accepted but ignored
T P ! W @
NOT supported: voice call originating (must be the last character in a
;
command line)
direct dialling from phonebook (must be the first character after D)
>
(see next table)
allow calling line id presentation for this call
i
restrict calling line id presentation for this call
I
control CUG information for this call; use +CCUG values
G
redial to the number last dialled
L
accepted and ignored from command line for compatibility reasons
any of not
listed above
Description
Originate call to phone number whose corresponding alphanumeric field is
<str>; search all ME, SIM (ADN) and TA memories (if available) for the entry;
used character set should be the one specified by +CSCS
Originate call to phone number found from location <n> in a specific memory
mem, which is one of the two letter memory abbreviations as returned by
+CPBS=? (without double quotes); location range can be queried with
+CPBR=?; note that in case of SIM ADN memory (SM) also D>SIM<n> shall be
accepted (due to inconsistency in 07.07)
Originate call to phone number in memory location <n>; memory selected with
+CPBS is used
Description
Causes the MT to enter the V.250 online data state and, with the TE, to
start the specified layer 2 protocol.
+cme error
x
x
x
+cme error
x
51/113
Advertisement
Table of Contents
