Table of Contents
Advertisement
19. FAX CLASS 2 RESPONSES
Below is a list of possible responses that a fax can give to the DTE during a Class 2 fax call.
They are defined in SP-2388 /7/.
Response
Description
+FCIG:
report a CIG frame received from remote, example: +FCIG:"
+FCFR
indicate that CFR (Confirmation to Receive) frame has been received
+FCON
indicate a facsimile connection, issued in the beginning of Phase B
+FCSI:
report a CSI frame received from remote, example: +FCSI:"
+FDCS:
report a DCS frame (sent or received), example: +FDCS:0,3,0,2,0,0,0,1
+FDIS:
report a DIS frame received from remote, example: +FDIS:1,3,0,2,3,1,0,3
+FDTC:
report a DTC frame received from remote, example: +FDTC:1,3,0,2,3,1,0,3
+FET:
report post message command in a receiving session, example (EOP): +FET:2
+FHNG:
report call termination status response, example (normal termination): +FHNG:0
+FHR:
report a received HDLC frame, only used when +FBUG parameter sets to 1
+FHT:
report a transmitted HDLC frame, only used when +FBUG parameter sets to 1
+FNSC:
report an NSC frame received from remote
+FNSF:
report an NSF frame received from remote
+FNSS:
report an NSS frame received from remote
+FPOLL
an indication of the remote having indicated that it has a document for polling
+FPTS:
page transfer status response as indicated by the receiver, be it our end or the other
+FTSI:
report a TSI frame received from remote, example: +FTSI:"
+FVOICE
an indication of the session having been suspended through a procedure interruption
+358105056888"
+358105056888"
+358105056888"
108/113
Advertisement
Table of Contents
