Nokia 9000i Service Manual page 210

RAE/RAK–1N
Service Software
2.3 – Test Power Management Inputs
This menu provides a test for the PDA power management inputs.
The enquired input parameters from the user are:
TimeOut default:
The input parameters are given as plain figures without units. Time
referred input values are given as hundreds of milliseconds.
PMI source is given as a result.
2.4 – Test QWERTY Keyboard
This menu provides tests for the PDA QWERTY keyboard.
User options are:
Method default:
TimeOut default:
The names of the pressed keys are displayed until the TimeOut measured
from the last key pressed expires. If no key is pressed at all until within
this timeout period the test is the TimeOut expires, considered to have
failed.
To exit from the testing mode: press any key on the PC keyboard and then
any key on the communicator.
2.5 – Test IR Communications
This menu provides a test for the PDA IR communications. One of the
two methods to test the IR can be chosen. Test uses half–duplex method
to test the input and the output capabilities of the target.
User options are:
Mode default: Output
Output Byte default: 55
The IR tranceiver of the host PC will be set to the opposite port than that
chosen for the service software, i.e. if the service software
communications port is set to COM1, then the IR tranceiver will be
connected to the COM2 and vice versa.
The IR speed defaults to the one used by the COM port for service
software communications. The speed of the IR may be changed by
changing the communications speed.
If the Mode is set to Output, the target sends the Output Byte via the
target's IR transceiver. The same byte is expected to be able to be read
via the the IR tranceiver connected to the service software PC. If the IR
transceiver receives the Output byte, the test is considered successful.
Page 7– 52
5.0s range: 0.1 – 25.5s
One Key Range:
25.5s Range:
range: Output
Input
range: 0 – FF(hex)
After Sales
Technical Documentation
One Key
0.1 – 25.5s
Amendment 1 04/97