Nokia 9000i Service Manual page 200

RAE/RAK–1N
Service Software
4.6 – Set UI factory Values
This function sets the UI parameters to factory default values.
Phone mode must be in the Local mode when this menu is selected.
4.7 – Set Factory Values
The selection sets all except IMEI factory values (including UI). Even
though no memory patch message is sent to mobile, the user is asked to
confirm the functions with <Y> key.
Note: RF Tuning values are lost when this function is performed.
5 – Power–up Selftests
This selection generates two windows:
When the window is activated, all test result fields have value 'No
response'. When responses are received, the values will be updated.
When <Esc> key is used, the previous menu is displayed. Below is the
list of DSP processor test faults. Only one fault value is indicated in the
DSP processor selftest message. MCU test results are indicated one by
one on the separate lines.
– RAM BUS Fault
– ASIC BUS Fault
– RFI BUS Fault
– Download Error
MCU test results will be one of the following: No Response, OK, NOT
EXECUTED, FAILED
When <F8> key is pressed any failed test results are displayed. If no
MCU BUS tests have failed, the display will say so. <Esc> key returns to
the previous menu.
Page 7– 42
After Sales
Technical Documentation
Amendment 1 04/97