Nokia 9000i Service Manual page 180

RAE/RAK–1N
Service Software
3.2 – Adjustments
All adjustments which have EEPROM saving selection have the next kind
of behaving with F2 and ESC keys.
When adjustment function is activated and <F2> key is used the program
will ask are the values saved to the EEPROM or not. If <Y> key is used,
adjustment values are saved to the EEPROM. If <N> or <Esc> key is used
the adjustment can be continued. If any other key is used nothing
happens.
When <Esc> key is used during adjustment function, the program will ask
are the values saved to the EEPROM or not. If <Y> key is used,
adjustment values are saved to the EEPROM and exit from the function is
done. If <N> key is used exit is done from the function and nothing is
saved to the EEPROM. If <Esc> key is used the adjustment can be
continued. If any other key is used nothing happens. When exit is made
from the adjustment menu, the used adjustment values are used with the
normal DSP control commands in the local mode (i.e power connection
diagram and power levels).
3.2.1 – Continuous Mode Channel
Continuous mode channel number can be selected from the Adjustments
menu. The real frequency (transmission or receiving frequency area)
depends on the Active Unit selection and the selected tuning function.
Active Unit defects to the frequency when no selection is made from the
Adjustments menu. Note that this is same selection as in the RF Controls
menu.
Page 7– 22
After Sales
Technical Documentation
Amendment 1 04/97