Front Fender Removal/Installation - Yamaha V star 1100 Owner's Manual

390
26
3. Remove the pivot bolt and washer.
4. Separate the sidestand from the bracket. Do not
lose the collar from the bracket boss.
5. Installation is the reverse of removal. Note the
following:
a. Apply a light coat of lithium soap grease to
the pivot surfaces of mounting bracket and
sidestand.
b. Make sure the collar is in place in the bracket
boss.
c. Install a new self-locking nut and torque the
nut to the 56 N•m (41 ft.-lb.).
FRONT FENDER
Removal/Installation
Refer to Figure 28.
CAUTION
Since the full size front fender on
XVS1100A models wraps low over the
front wheel, the motorcycle must be
raised very high to remove the front
wheel with the fender installed. Un
less you have a jack that can safely
provide the necessary clearance, re
SIDESTAND
1. Collar
2. Sidestand bracket
3. Pivot bolt
4. Washer
5. Bracket bolt
6. Locknut
7. Sidestand
8. Spring hook
9. Inner spring
10. Outer spring
27
move the fender while the front wheel
is installed on XVS1100A models.
1. On XVS1100 models, remove the front wheel as
described in Chapter Ten.
2. Remove the front fender bolts (Figure 29) from
the inside of the fender and remove the fender from
between the front fork legs. On XVS1100A models,
watch for the reflector bracket that sits between the
fender and fork leg boss.
3. Installation is the reverse of removal.
a. On XVS1100A models, install the reflector
bracket between the fender and the fork leg.
CHAPTER FOURTEEN